[ad_1]
Nintendo’s Switch is perhaps best known for blurring the lines between handheld consoles and those you plug into a TV. However, the tablet-like device can also run Android if you want, and it was recently upgraded to version 10.
It’s an upgrade that brings a lot of new features to the table, most of which can be considered must-have for regular use. The new port supports USB Power Delivery, as well as deep sleep modes that allow the unit’s battery to last for several weeks. There is also support for live updates, which should make ongoing maintenance easier, along with improvements to Bluetooth compatibility and the touchscreen.
Like most console hacks to run custom code, you need to have the right hardware version with the right firmware, as Nintendo repeats regularly to try and lock down hacks when possible. The setup has a few hurdles to jump through, but nothing too strenuous that would scare the average Hackaday reader off. Just make sure you don’t attempt this on a darling console, as there’s always a risk it will all end in tears. If you remove it, then you can turn your Nintendo Switch into a network switch. Net… tendo… Switch? Find a better pun in the comments.
[Thanks to David Beckershoff for the tip!]
[ad_2]
Source link