In the design of a nuclear reactor in Belgium, a defect



[ad_1]

Engie-Electrabel, operator and main shareholder of the Belgian Tianzh nuclear power plant, discovered a defect in the construction of the third nuclear reactor. According to local media, in the slab lighting, which was installed in the 1970s, there are some "anomalies". The reactor work was suspended indefinitely. According to her, after problems seen at the factory of the second plant "Dul", the operator decided to test the concrete slab in the ceiling of the five-storey armored bunker reactor " Tianzh ", in which the emergency systems. As stated by the publication, the plant operator discovered "anomalies in reinforcement of reinforced concrete, which was used in the construction of the building". The Belgian Federal Nuclear Safety Agency (FANC) reports that Soir has stated that the reactor will not be restarted until the resistance of the bunker of the power plant in which the defect has been found is restored. . According to the publication, this will only happen in September.

In early May, it was discovered that in the nuclear part of the first plant of the "Dul" nuclear power plant, which was not planned to prevent the cooling system, a leak occurred. is produced. The Belgian profile agency badured that the incident had no effect on the safety of plant personnel or on the environment.

There are two nuclear power plants on Belgian territory: Tianzh (the most powerful) on the banks of the Meuse and Dul in East Flanders. . Both are capable of producing about 6,000 MW of electricity and cover 55% of the country's needs. "Tianzh" was launched in 1975, "Dul" – a year earlier. The construction was carried out by American, French, German and Belgian energy companies.

In the summer of 2012, the third scheduled inspection reactor was shut down at the Dul Nuclear Power Plant. The specialists performed an ultrasound check, which revealed several thousand cracks on the body. The reactor was then shut down for six months to be tested, and restarted again

[ad_2]
Source link